Omron ZN-CTX21 - Recording Mode (REC); Integrated Power Reset Interval (INTEG)

4. Setting the Unit (Unit Operation)
4-12
(10) Recording Mode (REC)
Specifies the write operation to the SD memory card during recording.
The range of selection (Options):
CONT / RING
Initial value: CONT
Recording Mode
Operation
CONT
Continue mode
The unit outputs the files in the internal memory to the SD memory
card when the internal memory becomes full during recording, and
continues recording. If an error occurs due to no insertion of an SD
memory card, the unit stops recording and holds the data in the
internal memory.
RING
Ring mode
The unit overwrites the oldest data in the internal memory when the
internal memory becomes full, and continues recording.
Note
・A press of the SET/REC/STOP key (for 3 seconds or less) during recording enables the
unit to output the data accumulated so far in the internal memory to the SD memory card
without stopping recording.
(11) Integrated Power Reset Interval (INTEG)
Specifies the interval for measuring integrated power.
The range of selection (Options):
OFF / 30min./ 1h (hr.) / 24h
Initial value: OFF
Setting Value
Operation
OFF
The unit continuously measures the integrated power without
resetting the value to zero.
30min.
The unit measures the integrated value at the interval of 30 minutes;
at 0 and 30 minutes of every hour (0:00 to 0:30; 0:30 to 1:00; 1:00 to
1:30…).
1h
The unit measures the integrated value at the interval of one hour; at
0 minutes of every hour (0:00, 1:00, 2:00…).
24h
The unit measures the integrated value at the interval of 24 hours; at
0:00 of every day.
Note
When you press the MODE key and change the operation mode after changing the set
value, the unit resets the setting and restarts, clearing the ranking.
Important
Only the integrated power is reset on the display, not the integrated power that is output to
a file. Use the integration/summation function of the Station Utility to perform summation
on a PC