Omron ZN-CTX21 - End Time (ETIME); Elapsed Time (ELPSD)

4. Setting the Unit (Unit Operation)
4-10
(7) End Time (ETIME)
Specifies the recording end time.
Recording stops at a specified time every day.
The range of selection (Numeric input):
00:00 to 23:59
Initial value: 00:00
Note
・ETIME cannot be specified when ETRIG is set to "OFF" or "ELPSD".
・Recording stops when the specified end time is reached overriding a record start command
via key operation or communication.
Important
・Nothing happens if recording has already stopped when the specified end time is reached.
(8) Elapsed Time (ELPSD)
Specifies the elapsed time after recording starts until recording stops.
The range of selection (Numeric input):
0.05 (0 min. 5 sec.) to 999.59 (999 min. 59 sec.)
Initial value: 0.05
Note
・ELPSD cannot be specified when ETRIG is set to "OFF" or "TIME".
・Recording stops when the specified time is elapsed overriding a record stop command via
key operation or communication.
Important
・Nothing happens if recording has already stopped when the specified end time is reached.