Omron ZN-CTX21 - Writing the Setting Data (BCKUP); Time Setting (CLOCK)

4. Setting the Unit (Unit Operation)
4-16
(21) Writing the Setting Data (BCKUP)
Saves the unit setting data in an SD memory card as a backup.
Operation:
Insert an SD memory card and hold the SET/REC/STOP key.
Saving is complete when “DONE” is displayed.
Important
Only one setting data item (the setting data for only one unit) can be stored in a single SD
card as a backup. If an SD card containing an already-saved setting data backup is used, the
setting data in the card is overwritten. The same applies to a backup performed on other
Portable Power Monitor: the data is overwritten.
Note
・The setting data is written into the SYSTEM folder in the SD card.
・Setting data writing is not possible when ETC is set to "OFF".
(22) Time Setting (CLOCK)
Specifies if the time setting is required.
The range of selection (Options):
OFF / DISP
Initial value: OFF
Setting Value
Operation
OFF
Time setting is not available.
The D TA I L item is displayed when the ▽ key is pressed after the
setting is applied with the SET/REC/STOP key.
DISP
Time setting is available.
The YEAR item is displayed when the ▽ key is pressed after the
setting is applied with the SET/REC/STOP key.
Note
・The CLOCK setting is not possible when ETC is set to "OFF".
・The CLOCK setting returns to "OFF" when the unit is reset.