Omron ZN-CTX21 - 3.6 Connecting to Network; 3.6.1 Preparation

3. Check and Preparation
3-9
3.6 Connecting to Network
Network settings are required on the Portable Power Monitors to be connected to a network.
Connect the LAN cables after completing the network settings on the Portable Power Monitor
units.
Important
・A full understanding of LAN is required to connect Portable Power Monitors to a network.
・Establish a dedicated LAN for connecting Portable Power Monitors to a network.
・Connection to an in-house network or an existing LAN requires caution, since specific
restrictions or rules may have been applied to the IP address management. Consult your
network administrator. In case that such a network is used, however, OMRON cannot
guarantee the performance of the Portable Power Monitors and the PC software.
・The measurement operation mode (MODE) still must be set to "NORM" if the IP address
and subnet masks settings use its default values. Also set the network function availability
(NET) to "ON". Network connection is not possible when "SLEEP" or "HISPD"
measurement mode (MODE) is entered.
3.6.1 Preparation
Define the IP addresses and subnet masks to use before establishing network connection.
Setting Example
Portable Power Monitor IP Address
(Unit 1): 192.168.0.20 (Factory default)
(Unit 2): 192.168.0.21
PC IP Address
192.168.0.100
Subnet Mask
255.255.255.0 (Factory default)
Note
・Portable Power Monitors are assigned by the IP address: 192.168.0.20, and subnet
mask: 255.255.255.0 as the factory defaults.
・The IP addresses of Portable Power Monitors and the PC must be individually unique
LAN Cable
IP Address: 192.168.0.100
Subnet Mask: 255.255.255.0
IP Address: 192.168.0.20
Subnet Mask: 255.255.255.0
IP Address: 192.168.0.21
Subnet Mask: 255.255.255.0
W4S1
-
05C (Operation
check completed)