Omron ZN-CTX21 - Timer Setting (TIMER); Start Trigger (STRIG)

4. Setting the Unit (Unit Operation)
4-8
10 seconds
Approx. 25 days
20 seconds
Approx. 29 days
30 seconds
Approx. 30 days
1 minute
Approx. 32 days
* The table above only shows representative values. The actual battery life depends on the
measurement environment, recording interval, measurement mode as well as the type and
performance of the SD memory card and batteries to use.
(3) Timer Setting (TIMER)
Specifies if the timer function is required.
The range of selection (Options):
OFF / ON
Initial value: OFF
Setting Value
Operation
OFF
The timer function is not used.
Start trigger and End trigger are also set to OFF.
The MDOE item appears when the ▽
key is pressed after the
setting is applied with the SET/REC/STOP key.
ON
The timer function is used.
Start trigger and End trigger can be specified.
The STRIG item appears when the ▽ key is pressed after the
setting is applied with the SET/REC/STOP key.
Note
・The setting returns to "OFF" when FUN mode is exited, if both Start trigger (STRIG) and
End trigger (ETRIG) are set to "OFF".
(4) Start Trigger (STRIG)
Sets the recording start trigger.
The range of selection (Options):
OFF / TIME
Initial value: OFF
Setting Value
Operation
OFF
A long press (for 3 seconds or longer) of the SET/REC/STOP key
starts recording.
The ETRIG item appears when the ▽ key is pressed after the
setting is applied with the SET/REC/STOP key.
TIME
Recording starts when the specified start time is reached.
The STIME item appears when the ▽ key is pressed after the
setting is applied with the SET/REC/STOP key.
Note
・A long press (for 3 seconds or longer) of the SET/REC/STOP key starts recording
overriding the TIME setting.
・If a TIME setting is made, the "REC" indication keeps blinking (indicating that TIME has
been set) until recording starts.