Omron ZN-CTX21 - 3. Check and Preparation; 3.1 Checking the Package Contents; 3.2 Preparing the Required Items

3. Check and Preparation
3-1
3. Check and Preparation
3.1 Checking the Package Contents
This product package includes the following items:
□Main Unit ZN-CTX21
1
□AC Adapter or DC cable 1
□Alarm Output Connector 1
□Instruction Sheet 1
□Startup Guide 1
□Mounting Magnet (Pre-installed) 2
3.2 Preparing the Required Items
The following items are required to use this product.
(1) Common
□Dedicated CT: ZN-CT1-A 1 (Separately sold)
Up to three units can be connected when using a branch cable (ZN-CTM11-C)
□PC (personal computer) for the PC software 1
Refer to: 3.4.2 Operating Environment
□SD Memory Card (SDHC compatible) 1 (Recommended: HMC-SD291, 2 GB)
Used to save measured data or to relocate the data (when recording in a Portable Power
Monitor unit)
□AAA batteries (when using battery power supply) 2
Alkaline dry cells or nickel-metal hydride cells (Ni-MH)
Important
Manganese battery cells cannot be used.
Use two batteries of the same type. Do not mix new and used batteries.
(2) Network Connection
□LAN Cable (10BASE-T or 100BASE-TX; Safety Category 5e or higher; Straight Type)
□LAN Connection HUB (for 10BASE-T or 100BASE-TX)
Note
Generally, Portable Power Monitors should be connected to a PC via a HUB.