OneProd FALCON - Page 16

16
Brand of ACOEM
 Wi-Fi LAN connection PC- FALCON setting without WLS sensor:
Note: WLS sensor cannot be used simultaneously with this mode.
o On FALCON:
Setting > Network > Wi-Fi part
 Enabled: Yes
 Adhoc: No
 Save the setting
Setting > Network > Wi-Fi part
 Scan network until you detect the right SSID
 Set Authentication, Encryption and Key according to selected SSID
 DHCP: Yes
The IP address can be read in Setting > About information page.
If there is a DNS, it is also possible to access the instrument with its name. The name is:
Falcon_serial_number (e.g., Falcon_10015).
o On PC: the PC must also be connected to the same Wi-Fi LAN