OneProd FALCON - 1.2 Device Warnings and Connections

8
Brand of ACOEM
1.3 LIST OF SYMBOLS AND WARNING ON THE INSTRUMENT
Warning: whenever this symbol is present on the device, refer to the safety instructions and user
manuals.
The table below lists the warning signs and security present on the instrument.
Symbol
Signification
Position
Laser radiation
Refer to section "Laser Class 3R"
Rear side
(bottom)
Laser radiation class 3R
Refer to section "Laser Class 3R"
Rear side
(bottom)
Avoid exposure to beam
Refer to section "Laser Class 3R"
Rear side
(bottom)
Light Hazard Group 2
Refer to section "High-power white LED
flash and stroboscope"
Rear side
(bottom)
Refer to the safety instructions
documentation and the user manual
before connecting
Rear side
(bottom)
Laser aperture
Refer to section "Laser Class 3R"
Rear side
(top)
Battery replacement
Refer to section "Battery pack set-up"
Battery
compartment
CE certification data. Refer to the copy of
the CE APT2069 type certificate
Rear side
(center)
Do not dispose of this product as
unsorted household waste.
Refer to section "Dismantling/recycling"
Rear side
(center)
FCC and IC number. Refer to section
"Radio"
Rear side
(center)
External power connection: refer to
section "Main Power supply block"
Rear side
(bottom)
1.4 LIST OF SYMBOLS AND WARNING ON WLS
Warning: whenever this symbol is present on the device, refer to the safety instructions and user
manual.
The table below lists the warning signs and security present on the WLS sensor.
Symbol
Signification
Warning: refer to the safety
instructions and user manuals
Use a power source with limited power
(=> Mains Power supply bloc)
=> CE certification data
=> Dismantling/recycling
1.5 LASER
 Laser maintenance: the laser does not need maintenance or adjustment excluding cleaning the
glass with a cotton swab. Always shut off completely the device Falcon before this operation.
 Caution--use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure