EasyManua.ls Logo

OneProd FALCON - Battery Management; Battery Charge; Battery Replacement

OneProd FALCON
81 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
Brand of ACOEM
1.15 BATTERY MANAGEMENT
For battery management, please read the safety instructions delivered with the instrument (printed and
on the CDROM)
1.15.1 Battery charge
When using a new battery, leave the battery in charge for about 10 hours in order to achieve full charge. Do not
use the instrument prior to 2-3 hours of charge. Usual charging time is about 6 hours when instrument is switched
off.
Battery charge:
o Connect the instrument to the charger delivered with the instrument.
o Connect the charger to the mains. The instrument is automatically powered up. During the charge you
can continue using it. For a faster charge, it is recommended to switch the instrument off. A full charge
requires about 6 hours.
It is recommended to disconnect the charger from the mains when you are not using it.
1.15.2 Battery replacement
Safety instructions:
o Do not use batteries other than type PIL1133 provided for FALCON and identified as 01dB
Metravib WILPA 2344A
o Do not open or disassemble the battery pack. The pack includes protections and an assembly
essential for the safety that should be changed in no case.
o The battery pack is interchangeable only for maintenance purposes. The operating lifetime of the pack
is sufficient for a full working day. The pack should not be changed periodically to artificially increase its
lifetime. The pack is not intended for this type of use, which would result in a dangerous mechanical
wear.
o Do not short-circuit the terminals of the battery connector. For safety reasons, the battery pack
includes an internal non-resettable fuse. A short-circuit makes it unusable.
o Respect voltage, current and temperature indicated on the label of the battery.
o Do not expose the battery to water or condensation.
o Do not place the battery in fire or near any other source of temperature (> 70°C). This can cause
overheating or a fire start. Such use may also lead to a loss of performance and a significant reduction
of the lifetime of the battery.
o Disconnect the battery and the charger immediately in the following situation:
unusual odour
abnormally high temperature

Table of Contents

Other manuals for OneProd FALCON

Related product manuals