OneProd FALCON - 1.7 Remote Control Function

25
Brand of ACOEM
1.16 REMOTE DISPLAY & CONTROL FUNCTION
Procedure to take control of FALCON from a PC:
 Install Real VNC Viewer ® on the PC
 FALCON must be first networked by Ethernet (see § 1.12.3) or by Wi-Fi (see § 1.12.4) with the PC
 To work also with WLS Sensor, use the ‘Direct Wi-Fi connection PC- FALCON-WLS setting’ configuration.
 Run Real VNC Viewer ®
 Set the Input Server address: IP address of FALCON or its hostname (e.g., Falcon_10015) if there is a
DNS.
 It is then possible to control FALCON from the PC.
Note: it is possible to protect this access with a password: see § 2.10