OneProd FALCON - Using Wi-Fi

15
Brand of ACOEM
1.12.4 Using Wi-Fi
Check first if Wi-Fi is enabled in:
Shortcuts > Setting > > Wi-Fi = enabled
 Direct Wi-Fi connection PC- FALCON setting without WLS sensor:
o On FALCON:
Setting > Network > Wi-Fi part
 Enabled = Yes
 Adhoc = Yes
 SSID = My_ONEPROD_Instrument or other
 Canal = 5
 Authentication = none
 DHCP = No
 Set the IP address: Ex 192.168.1.16
Note: the first 3 numbers must be the same (192.168.1) and the last one different from that
of the PC (14 ≠ 16)
 Mask = 255.255.255.0
o On PC: Setup WIFI network
 DHCP = No
 Set the IP address, e.g., 192.168.1.14
 Mask: 255.255.255.0
 Scan Wi-Fi networks and select FALCON SSID.
Once the setting is done, to access the data use FALCON IP address, e.g., in the Explorer type
“\\192.168.1.16\Data”.
 Direct Wi-Fi connection PC- FALCON-WLS setting:
o On FALCON:
 First set the connection FALCON-WLS: see § 1.11.2
 Wait for sensor connection (status panel)
 In Setting > About information page check Falcon WIFI IP address
(192.168.1.xxx with xxx the last 3 digits of Falcon serial number)
o On PC: Setup Wi-Fi network
 DHCP = No
 Set the IP address: 192.168.1.yyy (yyy ≠ xxx)
 Mask: 255.255.255.0
 Scan Wi-Fi networks and select FALCON SSID (WLS_10015).
Once the setting is done, to access the data use FALCON IP address, e.g., in the Explorer type
“\\192.168.1.xxx\Data”.
Note: this type of communication can also be used if the WLS Sensor is switched off.