Onkyo NC-500

Other Information
47
Using timer functions
Setting the alarm start time
After completing the step 3 on page 46, do the
following procedures.
1. Press the Cursor
/ button to display “Alarm
Time” in the display area.
Press the SELECT button.
2. Press the Cursor / button to set the hour.
3. Press the Cursor
button to display “Mins”.
Press the Cursor / button to set the minute.
4. Press the Cursor
button to display “ AM/
PM” when you use the 12-hour format.
Press the Cursor
/ button to select either
“AM” or “PM”.
5. Press the SELECT button to save the settings
you have just made.
To return to normal display, press the SETUP
button.
Setting the alarm source
After completing the step 3 on page 46, do the
following procedures.
You can select the server, Internet radio, or FM/
AM radio as the playback source.
1. Press the Cursor
/ button to display “Alarm
Source” in the display area.
Press the SELECT button.
2. Use Cursor
/ to select the playback source.
Press the SELECT button to save the settings
you have just made.
3. Select a track (server) or preset station (AM/
FM radio/Internet radio) to play.
• When using the server as the playback source,
you can select the title to play with the Cursor
/ button, just as you do in normal play
mode selection.
• When using Internet radio as the playback
source, you can select your desired preset
station number with the Cursor
/ button.
• When using FM/AM radio as the playback
source, you can select your desired preset
station number with the Cursor
/ button.
Press the SELECT button to save the settings
To return to normal display, press the SETUP
button.
Notes:
If you select a title on the server or an Internet
radio title and the title cannot be played for some
reason (such as the PC being shut down), the NC-
500 will automatically choose the FM or AM
station that was used the last time.