66
Configuring Various Settings
Net-Tune Server Settings
You must determine which PC(s) on your LAN
should function as the Net-Tune server. There
must be at least one PC running the Net-Tune
Central software on the same LAN as the NC-
500. When you play digitally recorded music via
the NC-500, you will need to connect to a Net-
Tune server and access its music library.
The NC-500 searches for a server when it is
connected to the network for the first time, and
sets the preferred server parameter to the first
server found; however, you can change this
setting any time from the setup menu. Once you
have selected a server from the menu, that server
will be used as the preferred server; that is, the
NC-500 will first attempt to access your selected
server next time it is connected to the network.
If there is no server accessible on the network, the
NC-500 displays a “Server Timeout” message.
1. Make sure that the Net-Tune Central
software is running on at least one PC
on your LAN.
For information on the Net-Tune Central, see
the Net-Tune Central Help.
2. Check the network connection
between the NC-500 and the Net-Tune
server computer.
Make sure that the NC-500 is connected to the
same LAN as the Net-Tune server.
3. Choose your desired server.
Press the SETUP button, select “Server”
using the Cursor
/ button, and press the
SELECT button.
You are presented with the “Select Server”
setup menu.
Press the SELECT button to list the names of
available servers.
Press the Cursor
/ button repeatedly to
select your desired server and then press the
SELECT button.
To Next Page
Loading...
