Other Information
41
Listening to Radio Broadcasts
You can listen to radio broadcasts either by
manually tuning to a station or by selecting a
preset station.
Manually tuning to a station
1. Press the AUDIO INPUT button
repeatedly to display “FM Radio” or
“AM Radio”.
When using the remote controller, press the
TUNER button repeatedly to switch between
“FM Radio” and “AM Radio”.
2. Press the Cursor / button
repeatedly until your desired station’s
frequency is selected.
Autotuning
For FM broadcasts, you can press and hold the
Cursor
or button for a while and then release
it to have the NC-500 search for a station by
tuning the frequency up or down.
(Note autotuning does not store stations in
memory.)
With “<>Tune” displayed the frequency is tuned
up or down until an receivable station is found.
While the scanning is in progress, a “Scanning”
message are displayed on screen.
Indicates stereo
reception.
Indicates that pressing
or will scan
through frequencies.
Frequency
counts up.
Presetting FM/AM stations
The NC-500 provides a preset memory feature
that allows you to preset up to 40 FM and AM
stations by tuning to your desired station and then
assigning the station your desired preset number.
You can define a station name of up to 15
characters for each preset station.
Caution: Leaving the NC-500 unpowered (.e.g.,
with the power cable disconnected) for 2 weeks or
longer may result in losing all the memory
contents including your preset stations and text
information. If this occurs, you will need to
preset your desired stations over again.
1. Set the NC-500’s selector to FM Radio
or AM Radio.
2. Tune to your desired station
(frequency) by pressing the Cursor
/ button repeatedly.
✔STORE; indicates that you can preset the
station by pressing the SELECT button.
3. Press the SELECT button.
You are prompted to enter the station name.
Press [SELECT] to store.
(Ex.)
To Next Page
Loading...
Need help?
General
