Opel COMBO - Display indication; Deactivation; Fault

Driving and operating 229
indicated. The manoeuvre is
complete when the vehicle's front
wheels are out of the parking slot.
After deactivation ensure to take
control over the vehicle.
Display indication
The instructions on the display show:
● general hints and warning
messages
● the demand to stop the vehicle,
when a parking slot is detected
● the direction of driving during the
parking manoeuvre
● the demand to shift into reverse
or first gear
● the demand to stop or to drive
slowly
● the successful completion of the
parking manoeuvre indicated by
a pop-up symbol and a chime
● the cancelling of a parking
manoeuvre
Deactivation
Do not use the advanced parking
assist when a temporary spare wheel
is mounted. The rear view camera
may not work properly.
The current park assist manoeuvre is
cancelled via the button to return to
the previous screen in the Info
Display. To deactivate the system
completely, press ¼ in the centre
console.
The system is deactivated
automatically:
● if the ignition is switched off
● if stalling the engine
● if no manoeuvre is started within
five minutes of selection of the
type of manoeuvre
● after a prolonged stop of the
vehicle during a manoeuvre
● if the Electronic Stability Control
is triggered
● if the speed of the vehicle
exceeds the stated limit
● when the driver interrupts
movement of the steering wheel
● after seven manoeuvres for
entering a perpendicular parking
slot (a manoeuvre consists of
one rear move or one forward
move)
● after ten manoeuvres for entering
or exiting a parallel parking slot
● on opening a door or the load
compartment
● if one of the front wheels
encounters an obstacle
● parking manoeuvre successfully
ended
Deactivation by the driver or by the
system during manoeuvring will be
indicated on the display. Additionally,
an audible signal sounds.
The system is deactivated when a
plug is connected to the power outlet
of the trailer hitch.
Contact your dealer to switch off the
system for a prolonged period.
Fault
In the event of a fault, a message is
displayed in the Info Display,
accompanied by an audible signal.