Instruments and controls 97
Reset of service interval
After each service, the service
indicator must be reset to ensure
proper functionality. It is
recommended to seek the assistance
of a workshop.
If service is executed by yourself,
operate as following:
● switch off ignition
● press and hold the button
● switch on ignition, the distance
indication begins a countdown
● when the display indicates =0,
release the button again
The symbol C disappears.
Retrieving service information
The status of the service information
can be retrieved at any time via the
Info Display. Press Check in the
vehicle settings menu. The service
information is displayed for a few
seconds.
Info Display 3 108.
Control indicators
The control indicators described are
not present in all vehicles. The
description applies to all instrument
versions. Depending on the
equipment, the position of the control
indicators may vary. When the
ignition is switched on, most control
indicators will illuminate briefly as a
functionality test.
The control indicator colours mean:
red : danger, important reminder
yellow : warning, information, fault
green : confirmation of activation
blue : confirmation of activation
white : confirmation of activation
grey : system paused, at least one
system limitation has been
detected
Control indicators are located in the
Driver Information Centre.
Driver Information Centre 3 107.
Overview
The numbers in the overview table
indicate what to do, when a control
indicator illuminates or flashes.
1 : only for information
2 : information and warning
3 : seek the assistance of a
workshop
4 : stop engine and seek the
assistance of a workshop
5 : have the cause of the fault
remedied immediately by a
workshop
6 : stop vehicle, do not continue the
journey and seek the assistance
of a workshop
; / : 1 Turn signal 3 99
X
2 Seat belt reminder
3 99
v
5 Airbag and belt
tensioners 3 99
To Next Page
Loading...
