OPENTEXT Tableau TX1 - Page 115

OpenText Tableau Forensic TX1 Imager
The Information Company 115
8. To change the job settings, tap the 5 or Settings heading.
Select
the desired Hash type for the logical image job - MD5 and/or SHA-1. Note
that hash values for source files will be calculated based on the chosen hash
settings, even if no lx01 outputs are requested. In that case, the file data is still read
to allow for hash calculation, and the file-based hash values are stored in the
metadata output file.
Enable or disable Read-back verification. Read-back verification is not possible if
no lx01 outputs have been configured or if no hashes have been selected.
Set the desired source read Error handling mechanism for the job – Continue on
error or Stop on error. Note that read error handling in logical image jobs is distinct
from that of physical image jobs in that retries are not allowed. This is because file
read errors will typically not succeed after an initial failed read. Therefore, for logical
image jobs, the only error handling setting decision to make is whether to continue
with the job (skipping the unreadable file(s)) or to stop the job as soon as the first file
read error is encountered.
Note: When a read of a given source file fails and the Continue on error setting is
active, the unreadable file will not be acquired. In that case, the metadata output file
will show an error condition in the entry for the unreadable file, and the lx01 will
Copyright © 2022 Open Text. All rights reserved. Trademarks owned by Open Text.