146 The Information Company
started upon source drive connection. The screenshot below shows an example of this
new acquisition indication method.
Note: The green checkmark that indicates a given drive has been successfully acquired
will persist in the user interface until TX1 is power-cycled, at which time no drives will
indicate they were acquired (despite the fact that they may have been in a previous TX1
session). Also, if an acquired drive is removed and then reinstalled on TX1 within the
same session/power-cycle, that drive will show as having been acquired.
4.9.1 Encryption detection
TX1 automatically detects certain types of encryption present on attached drives. This
detection is possible for software-based encryption types that have known header
signatures. TX1 can also detect the hardware-based Opal encryption method. TX1 can
detect the following types of encryption:
• APFS
• Apple FileVault 2
• BestCrypt
• BitLocker
• BitLocker To Go
• Check Point Full Disk Encryption
Copyright © 2022 Open Text. All rights reserved. Trademarks owned by Open Text.
To Next Page
Loading...