OpenText Tableau Forensic TX1 Imager
The Information Company 33
After entering the desired PIN, tap the Submit button in the lower right corner of the
screen to begin the locking process. The system will prompt you for a second entry of the
same PIN to confirm the desired digits have been entered. After verifying that both PINs
match, the system will be locked. A message will appear at the top of the lock screen
stating the time at which the system was locked.
To unlock the system, simply enter the current PIN and tap the Submit button in the
lower right corner of the screen.
Note: The button at the bottom left of the keypad allows for randomizing the layout of the
digits on the keypad. This can be used to ensure that commonly used PINs do not create
a distinct pattern on the screen.
This PIN locking mechanism is temporary in the sense that a power cycle of TX1 will
remove the lock.
3.2.6 Updating TX1 firmware
TX1 firmware is stored on an SD card located in the back of the unit. When a TX1
firmware update becomes available on the Tableau website, you can update your TX1
firmware a number of ways. You can use the Tableau Firmware Update (TFU) utility to
update the SD card on any Windows-based computer system. Alternatively, TFU (starting
Copyright © 2022 Open Text. All rights reserved. Trademarks owned by Open Text.
To Next Page
Loading...