28 The Information Company
3.2.3 Default settings
Tap Defaults to display the Operations Defaults page.
Sever
al different entry methods are used for the settings on this page, including direct
data entry, sliders, radio buttons, and an Image Directory name builder area. As shown
above, the Date + Time directory path element boxes have been selected (in that order),
so therefore the image directory path is tx1_images/<Date+Time>.
Note: The source drive model number, Serial number, and Case ID are not used in this
example.
Tapping a selected directory path variable box deselects it. Changing the order of
selection changes the order in which each element is incorporated into the image
directory path.
Note: Certain combinations of image directory and image name settings can result in
filename duplication on the destination filesystem for a given job. TX1 checks for this
situation at job startup, and, if it detects a file name conflict, it automatically appends
sequential numbers to the subsequent filenames, as shown in the file browse example
below. Though this feature exists, it is recommended that the image directory and image
name values be set such that no conflicts occur.
Copyright © 2022 Open Text. All rights reserved. Trademarks owned by Open Text.
To Next Page
Loading...