OpenText Tableau Forensic TX1 Imager
The Information Company 173
5.4.3 Thunderbolt 2 adapter cable
Adapting from a Thunderbolt 2 connector on a Mac to TX1 requires two separate
adapters/cables. A Thunderbolt 2 to FireWire 800 (9-pin) adapter is used along with the
same FireWire 800 (9-pin to 9-pin) cable shown above to connect between the
Thunderbolt 2 port on the Macintosh and the TX1 FireWire 800 port. A Thunderbolt 2 to
FireWire 800 adapter is shown below.
6 Specifications and
troubleshooting
6.1 Specifications
Two SATA/SAS (6 GBPS) signal connectors
One USB 3.1 Gen 1 (5 GBPS) Standard-A connector
One 1394b “FireWire 800” signal connector
Copyright © 2022 Open Text. All rights reserved. Trademarks owned by Open Text.
To Next Page
Loading...