Optex DOS-20 - Page 35

Adjustment
35
Select [2-Point Adjustment]
using
, and press .
3
$GMXVW
㸱'2'26
2IIVHW$GMXVWPHQWPJ/
6SDQ$GMXVPHQW
3RLQW$GMXVWPHQW
,QLWLDOL]H$GMXVWPHQW9DOXH
6DOLQLW\$GMXVWPHQW368
$OWLWXGH$GMXVWPHQWP
4
$GMXVW
㸱'2'26
ࠉࠉࠉ3RLQW$GMXVWPHQW
PJ/ࠉ3RLQWࠉ3RLQW
'LVS
$GM
     

   
Enter the [Point 1] display,
[Point 1] adjusted, [Point 2] display,
and [Point 2] adjusted values in
this order.
$GMXVW
㸱'2'26
ࠉࠉࠉ3RLQW$GMXVWPHQW
Select a digit by and value by
, and press . The value is
set and the cursor moves to the next item.
When a value outside the set range is entered, a short beep sounds.
Pressing
simultaneously while entering a value resets the
value to the factory default setting.
By pressing or , the value returns to the one before changing it.
After entering the [Point 2] adjusted
value and pressing , a progress
bar is displayed.
When completed, the display returns
to the measurement value display.
Reference
When a 2-point adjustment is performed, the offset and span
adjusted values will automatically replace the values calculated
from the displayed and adjusted values of the 2-point adjustment.