Opticon OPI 2201 - Setting Image Capture Mode

Opticon
OPI 2201
Specifications Manual
54
17.3. Setting Image Capture Mode
Use the following settings to change the image capture mode. (Code reader mode
is enabled by default).
To set the scanner to image capture mode,
scan “ZZ”, ”D7I”, ”D7M”, and ”ZZ” in that order or use the 2D code setting.
To set the scanner to code reader mode,
scan “ZZ”, ”D37”, ”D7J”, and “ZZ” in that order or use the 2D code setting.
Functions Menu labels Menu codes
SET
_ZZ_
ZZ
Image capture mode
_+F_
+F
Code reader mode
_+I_
+I
END
_ZZ_
ZZ
2D Code Settings:
Functions Menu labels
Image capture mode
Code reader mode
Note: To adjust the brightness of the captured image refer to the following
gamma configuration settings.