Optos P200TxE - Device Failure Procedures; Cleaning Guidelines and Precautions

Chapter 1 - Warnings and cautions
CAUTION
Unauthorized changes or modifications will invalidate the warranty of this device.
The manufacturer is NOT responsible for any interference caused by using:
l Interconnect cables NOT supplied by Optos
l Unauthorized changes or modifications to this equipment
Do NOT use devices which intentionally transmit RF signals (cellular phones,
transceivers or radio controlled devices) in the vicinity of this equipment, as it may cause
performance outside the published specifications (see Recommended separation
distances on page76).
Adhering to the distance separation recommended will reduce the disturbances
recorded at the image level, but may NOT eliminate all disturbances (see List of
recommended separation distances on page76). However, when installed and
operated as specified herein the system will maintain its essential performance by
continuing to acquire, display and store diagnostic quality images safely.
It is recommended that the image server is not used adjacent to or stacked with other
equipment.
The use of parts and cables other than those specified may result in degraded
electromagnetic compatibility of the system.
1.6 Device failure
WARNING
In the unlikely event you hear a loud noise from the device, see smoke or smell burning,
stop imaging and isolate the device by unplugging from the mains power supply.
If you suspect the device may be faulty (see Troubleshooting on page65).
If the fault still persists, please contact your Optos representative (see Contact us on
page79).
CAUTION
The device is isolated from the mains by the main power cable and IEC connector. In an
emergency, the device should be isolated by unplugging from the mains power supply.
Ensure the mains socket is easily accessible.
1.7 Cleaning guidelines
The device cleaning instructions are detailed in this User Guide (see Cleaning on page60). Adhere to the
following cautions while cleaning the device.
CAUTION
Cleaning patient contact parts
In order to prevent any contamination always clean and disinfect parts of the equipment
which will be in contact with the patient (see Cleaning before each patient on page61).
Adequate cleaning and disinfection is necessary to prevent disease transmission.
Thoroughly clean and disinfect the equipment surfaces that contact the patient and all
equipment surfaces likely to become soiled during use.
Do NOT attempt to wash or immerse the patient contact parts (for example, forehead
pad, chin pad and face pad) in water or cleaning fluid.
Page 16 of 84 Part Number: G110230-003-ENG
English Copyright 2019-2021, Optos plc. All rights reserved.