Optos P200TxE - Logging into Review Clients; Using Standby Mode at Day End

Chapter 3 - Get started
3. Switch ON the scan head.
l If the scan head is in standby mode the status indicator will be blue. Press the blue status
indicator to switch ON the scan head.
l If the scan head has been shut down the status indicator will be OFF. Press the power switch
on the back of the scan head to the ON ( ) position. There will be a short delay while the
device starts up.
l The status lights on the front of the scan head cover will flicker and then settle on the green
light.
l The touch screen powers up.
4. The scan head takes less than five minutes to start up, please wait for the scan head to start up. The
following happens during start up:
l The system will run a series of self-tests during this time.
l The status indicator will be white while the self-tests are running.
l The imaging procedures will be available when the self-tests have completed and the status
indicator is green.
5. Enter your username and password on the touch screen when prompted. Usernames and
passwords are assigned by your System Administrator (see Managing user details on page55) (all
passwords are case sensitive).
Note
l If there is a network error when starting the scan head it is likely that there is a temporary problem
with the image server. You can attempt to clear problems by restarting the image server (see How
do I restart the image server? on page67).
l You will be unable to capture images if the self-tests have NOT been successful. Please restart the
scan head. If the problem persists please contact your Optos representative (see Contact us on
page79).
3.1.3 Switch on browser-based review clients
Captured images can be reviewed using the OptosAdvance software. You need to login to OptosAdvance
to access the patient details and images stored on the system.
Browser-based review clients have to be on the same network as the scan head and the image server.
Usually, browser-based review clients have been logged off at the end of each day. To login to a browser-
based review client:
1.
Press [Ctrl]+[Alt]+[Del] to display the Unlock Computer dialog box.
2.
Type your username and password. Select OK.
3. Connect to the OptosAdvance URL from your browser.
4. Enter your username and password when prompted. Usernames and passwords are assigned by
your System Administrator (see Managing user details on page55) (all passwords are case
sensitive).
3.2 Use standby mode at the end of each day
The scan head MUST be put into standby mode at the end of each working day.
Page 30 of 84 Part Number: G110230-003-ENG
English Copyright 2019-2021, Optos plc. All rights reserved.