Configuring the System
■
For a network connection, use a Secure Shell (SSH) session and enter root as the user name.
Determine the IP address by accessing your DHCP server for the address assigned to the
service processor MAC address (see the label on the storage controller). For example: ssh
root@192.168.128.256
2.
When prompted, enter the password changeme.
Note - This is the default password that provides initial access to Oracle ILOM. You can set a
different password for the appliance in step 5.
3.
At the command prompt, enter start /SP/console.
4.
To confirm that you want to start the console, enter y.
Text similar to the following is shown on the console:
SunOS Release 5.11 Version ak/generic@2013.06.05.0.0,1-1.6 64-bit
Copyright (c) 1983, 2013, Oracle and/or its affiliates. All rights reserved.
System configuration in progress.
Configuring version: ak/nas@2013.06.05.0.0,1-1.6
Creating active datasets ...... done.
Starting primordial svc.configd
SMF online in 2 seconds
Loading smf(5) service descriptions: 165/165
svccfg: Loaded 165 smf(5) service descriptions
Loading smf(5) service descriptions: 24/24
Applying profile install/akinstall.xml ... done.
Applying service layer generic ... done.
Applying service layer nas ... done.
Applying service layer SUNW,iwashi_plus ... done.
Applying service profile generic ... done.
Enabling auditing of Solaris commands ... done.
Shutting down svc.configd ... done.
Configuring devices.
Configuring network devices.
Sun ZFS Storage 7120 Version ak/SUNW,iwashi_plus@2013.06.05.0.0,1-1.6
Copyright (c) 2008, 2013, Oracle and/or its affiliates. All rights reserved.
Checking hardware configuration ... done.
Starting appliance configuration ........... done.
Press any key to begin configuring appliance: [*]
5.
To begin configuration, press any key.
Configuring the Appliance for the First Time 185
To Next Page
Loading...
