Performing Initial Configuration (CLI)
igb2 false 0:14:4f:8d:59:ac 0 Mbit/s
igb3 false 0:14:4f:8d:59:ad 0 Mbit/s
hostname:maintenance system setup net> datalinks show
Datalinks:
DATALINK CLASS LINKS LABEL
igb0 device igb0 Untitled Datalink
hostname:maintenance system setup net> interfaces show
Interfaces:
INTERFACE STATE CLASS LINKS ADDRS LABEL
igb0 up ip igb0 192.168.2.80/22 Untitled Interface
hostname:maintenance system setup net> done
To create a management interface now, use the following steps as an example:
a.
Go to maintenance system setup net, and then enter interfaces.
hostname:maintenance system setup net> interfaces
b.
Enter show to view the interface. Enter cd .. to return to the context for the
next step.
hostname:maintenance system setup net interfaces> show
Interfaces:
INTERFACE STATE CLASS LINKS ADDRS LABEL
igb0 up ip igb0 192.0.2.11/24 Untitled
Interface
hostname:maintenance system setup net interfaces> cd ..
c.
Configure routing for the interface labeled Untitled Interface. Enter cd .. to
return to the correct context for the next step.
For detailed information, see “Configuring Network Routing” in Oracle ZFS Storage
Appliance Administration Guide, Release OS8.6.x.
hostname:maintenance system setup net> routing
hostname:maintenance system setup net routing> create
hostname:maintenance system setup net route (uncommitted)> set destination=0.0.0.0
destination = 0.0.0.0 (uncommitted)
hostname:maintenance system setup net route (uncommitted)> set mask=0
mask = 0 (uncommitted)
hostname:maintenance system setup net route (uncommitted)> set interface=igb0
Configuring the Appliance for the First Time 203
To Next Page
Loading...
Need help?
General