6.3.4 USB Connection Procedure
This procedure should be performed only once for the first connection. It is not necessary to do
it from the next time.
However, the communication setting must be changed when switching between the USB connection and
the tool port connection.
6.3.5 Installation of FPWIN GR
Install the FPWIN GR (Relay type: Ver. 2.50 or later version) (Transistor type: Ver.2.70 or later
version) before connecting the FP-X with a PC.
Note:
Do not connect the FP-X to a PC with the USB cable before the FPWIN GR is installed or during
the installation.
If they are connected, the USB driver will not be installed correctly.
Reference: <6.3.9 Reinstallation of USB Driver>
Reference:
For the information on the installation of the FPWIN GR, <FPWIN GR Ver. 2 Operation Guide Book
ARCT1F332>
To Next Page
Loading...
