Changing communication mode of COM port
An F159 (MTRN) instruction can be executed to change between general-purpose serial communication
mode and computer link mode. To do so, specify H8000 for n (the number of transmission bytes) and
execute the instruction.
Changing from “general-purpose” to “computer link”
Changing from “computer link” to “general-purpose”
The COM port communication mode flag in R9032 or R9042 turns on when general-purpose serial
communication mode is selected.
Note:
• When the power is turned on, the operating mode selected in system register no. 412 takes effect.
It is not possible to change to the MODBUS RTU mode.
To Next Page
Loading...
