Panasonic AFPX-C30T - Page 234

- Setting of FP-X
1) FP-X System register setting
No. 412: Computer link mode
2) Setting of AFPX-COM5
Item
Setting value
Communication protocol
TCP
Action mode Server mode
Communication mode
Computer link
Source port No. 9094
Time out
0
UDP/IP can be used for the communication method.
In that case, change the communication method of the FP2 ET-LAN unit to UDP/IP.
Set the communication protocol of the AFP-COM5 to UDP, and set the send type to UNICAST.
Note:
For MEWTOCOL master function of the FP2 ET-LAN unit, MEWTOCOL-COM is not available. For
communicating with the FP-X by the computer link, transmit the MEWTOCOL-COM data format using
the transparent communication on the FP2 ET-LAN unit. In this case, an exclusive header is not required
for the ET-LAN unit.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com