11.4.5 Setting using FPWIN GR
1. Select [Online Edit Mode] under the [Online] on the menu bar, or press the [CTRL] and [F2] keys at
the same time, to switch to the [Online] screen.
2. Select or “Set PLC Password” under “Tool” on the menu bar. The following display will be shown.
1. Select "8 digits" for "Digit number".
2. Uncheck "Allow the download to older than
Version 2.5" i n "Setting for F P m emory
loader option".
3. Check the functions t o be used of "Options
for FP memory loader".
- Limited distribution function
→ ”
Allow t he download i n c ase of same
password”
- Enable the upload protection setting.
→ ”Set that PLC cannot be uploaded”
4. After setting the above check box, input a
8-digit password, and then c lick "Setting".
The setting has completed.
Note) This function is available only when the
version of FP-X is Ver2.5 or later and a
8-digit password has been set.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
To Next Page
Loading...
Need help?
General
