Panasonic CF-W2 Series Reference Manual

136
Dealing with Problems (Advanced)
Unable to automatically enter standby
or hibernation mode
z If a peripheral is connected to the computer, disconnect the device
z If there is a disk in the DVD-ROM & CD-R/RW drive that has been formatted
using B’s CLiP, the computer will not enter standby or hibernation mode.
Remove the disk
z When the internal LCD is closed, the computer may not enter standby or
hibernation mode. In order to activate standby or hibernation automatically
while using the computer with the internal LCD closed, set [Touch Pad] to
[Disable] in the [Main] menu of the Setup Utility
The computer does not resume z Did you disconnect the AC adaptor or the battery pack while the computer was
in standby mode? If the computer's power supply is disconnected while the
computer is in standby mode all unsaved data will be lost
z Did you slide the power switch and hold it for four seconds or more? If so, the
power will be turned off forcibly. In this case, all unsaved data will be lost
Battery Indicator
The red indicator lights z The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the battery indicator
light is orange. If you do not have an AC adaptor, save your data and power off
your computer. After replacing the battery pack with a fully charged one, turn
your computer on again
The red indicator blinks z Quickly save your data and power off your computer. Remove the battery pack
and disconnect the AC adaptor, then connect them again. If the problem
persists, contact your technical support office. The battery pack or charging
circuit may be defective
The orange indicator blinks z Battery cannot be recharged temporarily because the internal temperature of
the battery pack is outside the acceptable temperature range for recharging.
Once the range requirement is satisfied, charging begins automatically. Your
computer can be used normally in this state
Keyboard
Only numbers can be input
z Check whether the indicator is on. If it is on, the computer is in ten-key
mode. To disable the ten-key mode, press the
NumLk key (Î page 23)
Only capital letters are being input
z Check whether the indicator is on. If it is on, the computer is in Caps Lock
mode. To disable the Caps Lock mode, press the
Caps Lock key ( Î page 22)
Standby/Hibernation Function

Panasonic CF-W2 Series Specifications

General

Brand	Panasonic
Model	CF-W2 Series
Category	Desktop
Language	English