117
Setup Utility
The Setup Utility sets the computer's boot-up operating environment, i.e. passwords, startup
drive, etc. The following six menu items are available:
[Information], [Main], [Advanced], [Security], [Boot], [Exit]
1 Turn on or restart the computer.
2 Press the
F2
key while [Panasonic] boot screen is displayed soon
after the computer begins the startup procedure.
When the password is set, the screen shown at left will be displayed. Enter your
password, and press
the
Enter
key.
When the Setup Utility is started with Supervisor Password
z You can register all items of the Setup Utility
When the Setup Utility is started with User Password
z On the [Advanced] and the [Boot] menu:
• You can view the settings, but cannot change it
z On the [Security] menu:
• [Clear registered SD card], [Set Supervisor Password] and [Hard Disk
Lock] will not be displayed
• [Password on boot], [SD Startup], [SD Setting Method], [Setup Utility
Prompt], [Boot First Menu] and [User Password Protection] will be
displayed, but cannot be set
• The User Password can be changed only when [User Password
Protection] has been set to [No Protection]. The User Password cannot be
deleted
z On the [Exit] menu:
• [Get Default Values] option will not be displayed
z The
F9
key does not work
NOTE
z When [Password on boot] in the Setup Utility is set to [Disable]:
• When the computer is started up, entering a password is not necessary
Running the Setup Utility
To Next Page
Loading...
Need help?
General