146
Dealing with Problems (Advanced)
Touch Pad
The cursor cannot be controlled
properly
z If you are using an external mouse, ensure that it has been connected correctly
z Restart the computer by using the keyboard
(Press the key, the
U
key, and select [Restart] with Î Í Ï Ð, then press
the
Enter
key)
z If the computer does not respond to keyboard commands, read "No response"
(Î page 147)
Unable to input using the touch pad z Has the Setup Utility been used to set [Touch Pad] to [Enable]?
z When external mouse drivers are installed (e.g., IntelliMouse), the touch pad
may not be used
z Has the touch pad driver been properly installed?
Sound
The sound is not heard z Try changing the mute by pressing the
Fn
+
F4
key or the
Fn
+
F6
key
Volume does not change when the
Fn
+
F5
key or the
Fn
+
F6
key is
pressed
z If the Windows sound function is not active, the volume will not change even if
is displayed
The audio is distorted z Audio distortion may occur when operations are performed by pressing the
Fn
key in combination with another key. Stop playing and start again
SD Memory Card/MultiMedia Card
Cannot use SD memory card security
function
z The SD memory card must be set up in order to use the security function
(Î page 86)
Cannot log-on to Windows with the SD
memory card
z Windows log-on user name and password are not set in the SD memory card
correctly
Enter the Windows user name and password without using the SD memory
card
After logging on to Windows, set the same user name and the password on the
SD memory card and Windows, using one of the following operations:
• Change the setting of the SD memory card side by [SD Card Setup]
• Change the setting of the Windows side by [Control Panel] (Î page 50)
To Next Page
Loading...
Need help?
General