85
SD Memory Card Security Function
When you initialize an SD memory card, you can insert it, instead of entering a password, in
the following cases.
NOTE
z Without using the SD memory card, you can also start your computer or log-on to
Windows by entering the correct password
z This security function can only be used with SD memory cards. The security function
cannot be used with MultiMedia cards
Before Initialization (SD Card Setup)
z To use when starting the computer:
Set the Supervisor Password in the Setup Utility (Î page 45). You can also set it during
the initialization procedure
z To use when logging on to Windows/resuming from the standby or hibernation
mode, or while the screensaver is active:
The Windows log-on user and password must be set in [Control Panel] in advance
(Î page 50)
NOTE
z Use the formatted SD memory card (Î page 80)
z When starting the computer z When logging on to Windows/
resuming from the standby or
hibernation mode, or while the
screensaver is active
Windows log-on screen
Set the SD memory card Set the SD memory card
Windows log-on screen appears Windows desktop appears