To Next Page

To Previous Page

Inserting a Disk

z Removing

Hold down on the center spindle (C) and gently lift up on the edge of the disk.

4 Close the disk cover.

NOTE

z When using B's Recorder or B’s CLiP: Î page 73

z If a hand is on the disk cover or the display is closed, and the disk cover cannot open,

the drive will not be accessed correctly. In this case, open and close the disk cover

once, and then re-attempt access

z If the vibration of the DVD-ROM & CD-R/RW drive is excessive, check to see if the

disk is inserted correctly, and check that the disk is in good condition. If the disk is

good and inserted correctly, set [CD/DVD Drive Speed] to [Low] in the Setup Utility.

Or, when writing to a disk using B's Recorder, you can minimize vibration while writing

by setting the writing speed at [8x] or less

z For AutoPlay CDs:

• If an AutoPlay CD does not start after the computer resumes from the standby or

hibernation modes, remove the disk from the drive, then reinsert the disk again after

a 15 second wait

• An AutoPlay CD may start during file access, depending on the status of the disk

z When playing back movies from a disk, note that smooth playback may not be

possible in some cases

Power-saving Mode

If the DVD-ROM & CD-R/RW drive has not been accessed within 30 seconds, the drive motor

will automatically shut down to reduce the power consumption. When the DVD-ROM & CD-

R/RW drive is accessed once again, the power of the drive motor is turned on. However,

approximately 30 seconds are required until data is actually read from the disk.

Panasonic CF-W2 Series Reference Manual

Other manuals for Panasonic CF-W2 Series