Panasonic CU-8ME1XPK - Page 3

PACD011001C2
ii Table of Contents
1.21 Oil Temperature Sensor (8 and 10 Hp only) ..........................................54
1.22 Louver Control for Preventing Ceiling Dirt..............................................55
1.23 Thermostat Sensor in Remote Controller...............................................56
1.24 Freeze Prevention..................................................................................58
3DUW6 7HVW#2SHUDWLRQ 11111111111111111111111111111111111111111111111111111111111111111 8<
1. Test Operation ......................................................................................60
1.1 Procedure and Outline ...........................................................................60
1.2 When Power is Turned On.....................................................................62
1.3 Outdoor Unit PC Board Ass’y.................................................................63
1.4 Setting Modes (MX1 Series) ..................................................................67
1.5 Setting Modes (ME1 Series) ..................................................................73
1.6 Sequential Start......................................................................................79
1.7 BMS Interface Adaptor for Outdoor Unit (MX1 Series) ..........................80
1.8 BMS Interface Adaptor for Outdoor Unit (ME1 Series) ..........................83
1.9 Cool / Heat Mode Selection (MX1 Series)..............................................87
1.10 Cool / Heat Mode Switching (ME1 Series).............................................92
1.11 Low Noise / Demand Operation (MX1 Series) .......................................94
1.12 Low Noise Operation (ME1 Series)........................................................96
1.13 Demand Control (ME1 Series) ...............................................................97
1.14 Wiring Check Operation .........................................................................98
1.15 Indoor Unit PCB Ass’y............................................................................99
1.16 Remote Controllers (Wired and Wireless)............................................100
1.17 Control by Remote Controller
(Double Remote Controllers, Group, Remote).....................................106
1.18 Indoor Field Setting ..............................................................................108
1.19 Centralised Control Group No. Setting.................................................110
1.20 Setting of Master Remote Controller....................................................112
1.21 Centralised Control Devices.................................................................114
1.22 Central Remote Controller (CZ-01ESM11P)........................................116
1.23 Unified ON/OFF Controller (CZ-01ANA11P)........................................123
1.24 Schedule Timer (CZ-01ESW11P) ........................................................126
1.25 Combining Different Types of Centralised Control Devices .................130
3DUW#7 7URXEOHVKRRWLQJ 1111111111111111111111111111111111111111111111111111111111111 468
1. Operation Flowcharts..........................................................................137
1.1 Indoor Unit Operation Flowchart ..........................................................137
1.2 Outdoor Unit Operation Flowchart........................................................142
2. Troubleshooting by Remote Controller ...............................................146
2.1 The INSPECTION / TEST Button.........................................................146
2.2 Self-diagnosis by Wired Remote Controller .........................................147
2.3 Self-diagnosis by Wireless Remote Controller.....................................148
2.4 Operation of The Remote Controller’s Inspection /
Test Operation Button ..........................................................................151
2.5 Remote Controller Service Mode .........................................................152
2.6 Remote Controller Self-Diagnosis Function
(Display of Malfunction Code) ..............................................................154
3. Troubleshooting ..................................................................................156
3.1 Indoor Unit: Error of External Protection Device ..................................156
3.2 Indoor Unit: PC Board Defect...............................................................157
3.3 Indoor Unit: Malfunction of Drain Level Control System (33H).............158