Panasonic CU-8ME1XPK - Page 89

Test Operation PACD011001C2
68 Test Operation Urban Multi “MX1, ME1 Series” Using R-22
1.4.1 Setting Mode 1
Note:
1. CU-5 is completed by low noise setting.
2. BMS interface adaptor for outdoor unit is required if cool/heat selection set to MASTER or SLAVE, or if
low noise operation is set to ON. For further information, see page 80.
The factory settings are:
Individual (C/H SELECT), OFF (L.N.O.P.), ON (SEQ. START)
You can change the cool/heat selection permission, low noise and
sequential start settings by pushing the SET switch.
To skip settings you don't want to change, push the RETURN switch
and go to the next setting.
Change cool/heat
selection to MASTER.
An optional BMS interface adaptor for outdoor unit is required
if you have set cool/heat selection to MASTER or SLAVE.
If carried out from the cool/heat selector:
Change low noise operation to "ON".
BMS interface adaptor for outdoor unit is required
if low noise operation is set to "ON".
Change sequential start to "OFF".
Setting complete
GROUP MASTER (cool/heat selection),
ON (low noise), OFF (sequential start)
MODE TEST L.N.O.P.
SEQ.
IND MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
SET
MODE TEST L.N.O.P.
SEQ.
IND
MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
SET
MODE TEST L.N.O.P.
SEQ.
IND
MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
MODE TEST L.N.O.P.
SEQ.
IND
MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
SET
SET
MODE TEST L.N.O.P.
SEQ.
IND
MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
MODE TEST L.N.O.P.
SEQ.
IND
MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
SET
SET
MODE TEST L.N.O.P.
SEQ.
IND
MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
MODE TEST L.N.O.P.
SEQ.
IND
MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
SET
MODE TEST L.N.O.P.
SEQ.
IND
MASTER SLAVE
START
H1P H2P H3P H4P H5P H6P H7P
C/H SELECT
C/H
SELECT
SS1
IN/D
UNIT
OUT/D
UNIT
H/C
SELECT
SS1
IN/D
UNIT
OUT/D
UNIT
Cool/heat selection setting
(SS1)
(Factory set)
If carried out from the indoor unit remote controller:
SET
RETURN
RETURN
RETURN
Monitor mode
MODE
Setting mode 2
MODE
Push and hold for 5 sec.
C/H SELECT
(VF016)