General Issues
Operation
Page
Cannot operate the TV
or
Set
• Change the manufacturer code
on
the remote control. 56
Top
Box with the unit's remote
• Select TV or Set
Top
Box mode
on
the remote control. 56
control.
The remote control doesn't
• The remote control code is wrong. Change to the correct code. 48
work.
• The batteries are depleted. Replace them with new ones.
5
• Point the remote control at the remote control sensor
on
the main unit.
5
• Remove obstacles between the remote control and main unit.
-
• Remove dust from the transmission window and the unit's sensor. -
• Colored glass may obstruct the signal reception/transmission.
-
• Don't place the signal sensor
in
direct sunlight or
in
areas that may be
-
subject to sun exposure.
• It may be necessary to set the code on the remote control again after
48
changing the batteries.
• It may be necessary to set the manufacturer code again after 56
changing the batteries.
The unit is
on
but cannot be
• Some operations are prohibited by the disc.
-
operated.
• The unit is warm ("U59" appears on the unit's display). Wait until "U59"
-
disappears.
• One of the unit's safety devices may have been activated.
-
Reset the unit as follows:
Press [POWER
6/1]
on the main unit to switch to off.
If the unit doesn't switch to off, reset the unit
(-+ 70, 'To restore the
unit if it freezes").
"U88"
is
displayed and the disc
•
The
unit
is
carrying
out
the
recovery
process.
Do
the
following
to
eject
the
disc:
-
cannot be ejected.
(1) Press [POWER
6/1]
on
the main unit to switch to off.
If the unit doesn't switch to off, reset the unit
(-+ 70,
"To
restore the
unit if it freezes").
(2) While the unit
is
off, press and hold
[II]
and [CH 1\) on the main unit
at the same time for about 5 seconds. (Ejection may take extra time
depending on discs.) The disc may be defective. Try another disc.
Cannot eject a disc.
• The unit is recording.
-
• The unit may have a problem. Eject the disc as
in
(2) above.
-
Startup
is
slow.
• Startup takes time
in
the following situations: -
- A disc other than a DVD-RAM is inserted.
- The clock is not set.
- Immediately after a power failure or the
AC
power supply cord
is
connected.
- When the unit is connected with an HDMI cable.
A password screen appears
• If the unit starts receiving a broadcast with the set rating information,
47
and you are unable to view or
a password screen appears and you will be unable to view or record.
record.
Enter your password to continue.
Time is incorrect after using
• Try again. If the time is still incorrect, set the clock manually. 49
Auto Clock Setting.
Cannot set "24p Output for
• Only when the unit is connected to the HDMI terminal of a TV 55
DVD-Video".
supporting 24p, you can set "24p Output for DVD-Video".
In
some
cases where the unit is connected to a TV via an amplifier/receiver
through the HDMI terminals, you may not be able to set
it.
In
this
case, connect the unit to a TV through the HDMI terminal and
connect it to the amplifier/receiver through any terminal other than
HDM!.
ROT9046
To Next Page
Loading...
Need help?
General
