Setti the Channels and Clock
Acquiring
the
setting
information
from
the
TV (VIERA)
If this unit is connected to a Panasonic TV (VIERA) supporting HOAVI
Control 3 via an HOMI cable, then the setting information on the TV is
acquired by this unit when the unit is turned
on
for the first time. Please
proceed to the following steps.
The following screen is displayed
in
the language set
on
the VIERA.
- The language setting screen may be displayed depending on the usage
environment. Press
[A,
Tl
to select language, then press [OK].
oQuick Start Function:
..
, T to select "On" or "Off",
then~
a
Channel
information acquisition:
..
, T to select "Set Channels
via VIERA Link", then
~
• Acquires the following information from the
TV
(VIERA).
- The types of transmission
- Channel Map
- Closed caption
When the settings are complete, the time confirmation screen is
displayed.
e Confirm the time, then
~
- For details of the time information
(-+
13, Tips, Notes)
© Tips
•
If
you
do
not
want
to
acquire
the
setting
information
from
the
VIERA
Press [A,
T]
to select "Set Channels
without VIERA Link" or "Set No
Channels with this unit", then press
[OK] in step
2.
- When connecting the cable from the
wall (cable
TV
or antenna) to the unit's
RF IN:
Select "Set Channels without
VIERA
Link".
The unit then displays the source
selection screen
(-+
13, left column,
step 6).
-When
not connecting the cable from
the wall (cable TV or antenna) to the
unit's RF IN:
Select "Set No Channels with this
unit".
The unit then displays "Set Clock
Manually" screen
(-+
13, Manual
Clock Setting).
• If "Automatic Clock and Channel
Settings" screen is displayed, the
channel information could not be
acquired from the TV (VIERA). Please go
to step 5 on page 12.
To
return
to
the
previous
screen
Press [RETURN].
@ Notes
• Acquisition of the setting information
is not supported by all Panasonic
TVs
(VIERA).
• The acquisition may take some time
depending on the VIERA setting
information.
DIGITALTELEVISION TRANSITION NOTICE
(Only
for U.S.A.)
This device contains a digital television tuner, so it should receive digital over the air
TV
programming, with a suitable
antenna, after the end of full-power analog TV broadcasting in the United States (as required by law)
on
February
17,2009. Some older television receivers, if they rely on a
TV
antenna, will need a
TV
Converter to receive over the
air digital programming, but should continue to work as before for other purposes (e.g., for watching low-power
TV
stations still broadcasting in analog, watching prerecorded movies,
or
playing video games). When a Converter is
used with an older television receiver, a signal splitter might be necessary to continue to receive low-power analog
broadcasts via an antenna. For more information, please see www.OTV.gov
or
1-888-CALL-FCC. For information
on
the TV Converter program, and on government coupons that may be used toward the purchase of one, see
www.dtv2009.gov,
or
call the NTIA at 1-888-0TV-2009.
Please check with your cable or satellite service provider
if
you have questions about your cable or
satellite set-top box.
RQT9046
To Next Page
Loading...
Need help?
General
