Panasonic FPG-XY64D2P-A - 1:1 Communication with Computer

Communication
FPΣ User's Manual
178
• Settings for COM port 1 (FPG-COM1, FPG-COM2)
No. Name Set value
410
COM port 1 - station number 1
412
COM port 1 - communication mode MEWTOCOL-COM Master/Slave
413 COM port 1 - communication format
*)
Data length: 7 bits/8 bits
Parity: None/Odd/Even
Stop bit: 1 bit/2 bits
End code: CR
Start code: No STX
415
COM port 1 - baud rate
*)
2400–115200bit/s
*)
The setting must match the external device connected to the communication port.
• Settings for COM port 2 (FPG-COM2, FPG-COM4)
No. Name Set value
411
COM port 2 - station number 1
412
COM port 2 - communication mode MEWTOCOL-COM Master/Slave
414 COM port 2 - communication format
*)
Data length: 7 bits/8 bits
Parity: None/Odd/Even
Stop bit: 1 bit/2 bits
End code: CR
Start code: No STX
415
COM port 2 - baud rate
*)
2400–115200bit/s
*)
The setting must match the external device connected to the communication port.
Programming
There is no programming required on the slave. Only the station number and the
communication parameters must be set in the system registers. The program for the master
side must send and receive commands according to the MEWTOCOL-COM protocol.
MEWTOCOL-COM contains the commands used to control and monitor the slave operation.
If a software program such as PCWAY is used on the computer side, PLC data can easily be
read and written without having to think about the MEWTOCOL-COM protocol.
8.5.5.1 1:1 Communication with Computer
For a 1:1 MEWTOCOL-COM connection between the FPΣ and a computer, an RS232C cable
is needed. Communication is performed via commands from the computer and responses
from the PLC.


RS232C
1:1 MEWTOCOL-COM connection between a computer and the FPΣ
1
Command message
2
Response message