Installing/Removing the Storage Memory Card
CAUTION
• Before touching the product (PBX, cards, etc.), discharge static electricity by touching ground or
wearing
an earthing strap. Failure to do so may cause the PBX to malfunction due to static electricity.
• When installing or removing the Storage Memory Card, the power switch must be turned off.
• When installing or removing the Storage Memory Card, do not put pressure on any parts of the mother
board. Doing so may result in damage to the PBX.
• The Storage Memory Card contains software for all the processes of the PBX and all the customer
data. Therefore, do not allow unauthorised access to prevent data leakage.
• To prevent data leakage, render the Storage Memory Card physically unusable before disposal.
Notice
• Use only the Storage Memory Card included with the PBX, or a Panasonic optional upgrade Storage
Memory Card.
• The Storage Memory Card must be inserted in the Storage Memory Card slot of the mother board
before startup.
Note
• The is shown on the label of your Storage Memory Card to indicate the direction for inserting the
Storage Memory Card.
• The maximum length of file names for files that are to be stored in the Storage Memory Card is 60
characters.
1. Turn the screw anticlockwise to loosen.
132 Installation Manual
4.2.6 Installing/Removing the Storage Memory Card
To Next Page
Loading...
