• When using VPSS, opposing subnets of
KX-NS1000 PBXs are automatically configured. However,
subnets created by subsequent external routers are not taken into account.
• In routing settings for crossing subnets, a maximum of 4 network addresses for adjacent segments, satellite
offices, etc., can be configured for each site. These settings are configured in the VPSS Advanced Settings.
PC Programming Manual References
27.9 Router Configuration—VPN—[3-1] VPSS
8.6.25 Router Command
Description
You can enter router commands from Web Maintenance Console. You can reference the built-in router’s
settings in the commands’ results.
The following commands are available.
Command Description
ROUTE Display the connected route information cache.
NETSTAT Display the status for each interface.
ARP Display the ARP table state.
DNSFLUSH Clear the DNS cache.
Conditions
• Users with User (Admin) privileges or higher can access this feature.
PC Programming Manual References
7.8.2 Utility—Command—Router Command
8.6.26 WAN Port Mirroring
Description
This feature mirrors the contents of packets sent and received on the WAN interface on the MNT port. With
WAN port mirroring, you can analyse the contents of packets that pass through the WAN port.
You can enable/disable WAN port mirroring.
Conditions
• Users with User (Admin) privileges or higher can access this feature.
PC Programming Manual References
28.1
Network Service—[1] IP Address/Ports—Advanced Settings—
Port Mirroring—Packet
kind for mirroring
Installation Manual 399
8.6.26 WAN Port Mirroring
To Next Page
Loading...
