Feature Description & Reference
Pass
Through
IPsec Pass-through Allows IPsec protocol packets to/from a
specified
device on the LAN to pass across the
WAN–LAN boundary.
® 8.6.19 IPsec Pass-through
PPTP Pass-through Allows PPTP protocol packets to/from a
specified
device on the LAN to pass across the
WAN–LAN boundary.
® 8.6.20 PPTP Pass-through
L2TP Pass-through Allows L2TP protocol packets to/from a
specified
device on the LAN to pass across the
WAN–LAN boundary.
® 8.6.21 L2TP Pass-through
Quality of Service (QoS) Quality of Service settings offered by the
built-in router.
® 8.6.22 Quality of Service (QoS)
VPN IPsec VPN connection over IPsec.
® 8.6.23 VPN—IPsec
VPN Simple Settings Provides simple VPN connectivity.
® 5.4.1 Easy Setup Wizard
® 8.6.24 VPN—VPSS Setting
Router Command Displays the built-in router’s status.
® 8.6.25 Router Command
WAN Port Mirroring Mirrors traffic from the WAN interface onto the
MNT port.
® 8.6.26 WAN Port Mirroring
Conditions
• This PBX supports only IPv4. It does not support IPv6. However, the IPv6 Bridge feature is supported.
For details, refer to 8.6.6 Protocol Bridge—IPv6 Bridge
.
• KX-NSN101 (Built-in Router) is required to use all the features in this section. This activation key is required
at each site where the built-in router will be used.
8.6.2 WAN Connection
Description
The following protocols are supported for setting the IP address of the WAN interface.
Protocol Description
IPoE Sets a static IP address or retrieves an IP address dynamically
from a DHCP server using the DHCP client feature.
PPPoE Obtains an IP address dynamically from a PPPoE server.
Installation Manual 379
8.6.2 WAN Connection
To Next Page
Loading...
