5. The
activation keys will be copied to the Master unit, and then the activation keys that Slave units require
will be copied to the Slave units of the One-look network. When installation is complete, the message,
"The activation key has been installed and activated successfully!" is displayed.
6. Click OK.
Notice
The
activation key file can only be installed in the PBX with the MPR ID number entered when the activation
key file was downloaded. The activation key file cannot be reissued unless the mother board crashes.
Note
• You
can click the provided link to directly access activation key information and programme the number
of activated IP trunks and IP softphones.
• For information about programming activation keys using Web Maintenance Console, refer to "9.3 PBX
Configuration—[1-1] Configuration—Slot—Activation Key Status" in the PC Programming Manual.
5.4.5 Configuration of the Activation Keys
Depending on your configuration, it may be necessary to programme the number of provided IP Trunk channels
to be used for H.323 trunks. By default, all of the provided IP Trunk channels will be used for SIP trunks.
Similarly, you can programme how many IP softphone(s) can be used through the IP Softphone/IP Proprietary
Telephone activation key. By default, only IP softphone(s) can be used through the IP Softphone/IP Proprietary
Telephone activation key.
1.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b. Click Activation Key.
2.
a. In Number
of activated IP-GW, type the number of
IP Trunk channels to be used for H.323 trunks.
Note
If you have changed the value for Number of
activated IP-GW, you must click Execute to
restart the V-IPGW16 cards for the change to
take effect.
b. In Number of activated IP-Softphone, type the
number of IP softphones to be used through the IP
Softphone/IP Proprietary Telephone activation key.
3. Click OK.
228 Installation Manual
5.4.5 Configuration of the Activation Keys
To Next Page
Loading...
