Notice
The Slave unit will restart. Depending on the makeup of the network, it may take 15 minutes or more for
the unit to restart in Isolated mode.
Note
The Slave site can act in Isolated mode in the following conditions:
• The connection to the Master site has failed.
• The
connection to the Backup master site has failed. (If a backup master exists in the One-look network)
• The Isolated Mode setting is enabled in the Slave unit.
LED Indication
Operating
Status
Slave Unit
STATUS
LED
MASTER
LED
Normal Green ON Amber ON
Isolated
Mode
Green ON Red
Flashing
For more information about LED indications, refer to "LED Indications" in "4.3.1 Mother Board".
Note
When adding KX-NS300
, KX-NS500, and KX-NS700 PBXs as Slave units, the PBX MODE LED of each
unit shows the One-look network registration status instead of the MASTER MODE LED of the
KX-NS1000. For details, refer to the Installation Manual of the corresponding PBX.
Similarly, the System Alarm button set for the flexible button on the PT lights to indicate the PBX status has
changed, and a message will be displayed on the LCD on the PT.
For details, refer to "5.6.4 Local Alarm Information" in the Feature Guide.
Isolated Mode Programming Procedure
Enabling Isolated Mode
The Isolated Mode setting is set to Disable by default.
Follow the procedure below to enable this setting using Web Maintenance Console.
Procedure
1. Select the Slave unit to be programmed from the Home screen, or by using the site selection drop-down
menu.
2. Click Setup ® PBX Configuration ® Configuration ® Slot ® Site Property ® Main.
3. Select Enable for Isolated Mode.
4. Click OK.
Disabling Isolated Mode
You can disable the Isolated Mode setting using Web Maintenance Console.
Procedure
1. Select the Slave unit to be programmed from the Home screen, or by using the site selection drop-down
menu.
2. Click Setup ® PBX Configuration ® Configuration ® Slot ® Site Property ® Main.
3. Select Disable for Isolated Mode.
4. Click OK.
Installation Manual 365
8.4.2 One-look Networking Survivability
To Next Page
Loading...
