4.6.2 STACK-S (NCP) Card (KX-NS0131)
Function
A stacking card to be installed in the
MPR card slot of a KX-NCP500 or KX-NCP1000 to be used as a legacy
gateway.
This card can be used only with PCMPR Software Version 002.01000 or later.
LED
To STACK-M Card
Stacking Connector
Accessories and User-supplied Items
Accessories (included): Stacking cable ´ 1
User-supplied
(not included): None
WARNING
A lithium battery is used in the
STACK-S (NCP) card. There is a risk of explosion if the battery is
replaced with an incorrect type. Dispose of used batteries according to the manufacturer’s
instructions.
CAUTION
When installing or removing this card, the power switch must be turned off.
Notice
When
stacking other PBXs with the KX-NS1000, place them well within reach of the stacking cable (2 m).
LED Indications
STACK-S (NCP) Card
Indication Colour Description
CARD STATUS Green STACK-S (NCP) card status indication
• ON: INS (In Service)
Red STACK-S (NCP) card status indication
• ON: Fault
• Flashing: OUS (Out of Service)
170 Installation Manual
4.6.2 STACK-S (NCP) Card (KX-NS0131)
To Next Page
Loading...
