2.1 Basic System Construction
2.1.1 System Configurations
Main Unit
The main unit contains a mother board for controlling PBX functions.
Stand-alone System
A single
KX-NS1000 PBX can be used as a stand-alone system. A single KX-NS1000 used as a stand-alone
system controls all terminals, trunks, and applications.
Stacking PBXs as Legacy Gateways
Up to 2 KX-TDA/KX-TDE/KX-NCP series PBXs and KX-TDA100D PBXs can be connected to a KX-NS1000
to expand the usage of legacy terminals and trunks. A PBX connected to a KX-NS1000 functions as a legacy
gateway and will be controlled by the KX-NS1000.
To connect a PBX as a legacy gateway, install a STACK-M card in the KX-NS1000 and a STACK-S (NCP) or
STACK-S (TDE) card in the PBX. Then, connect the STACK-M card and the STACK-S (NCP)/STACK-S
(TDE) card with the stacking cable that is included with the STACK-S (NCP)/STACK-S (TDE) card.
For details about connecting PBXs as legacy gateways, see "4.6.2 STACK-S (NCP) Card (KX-NS0131)" and
"4.6.3 STACK-S (TDE) Card (KX-NS0132)".
Note
• For details about connecting a
KX-NS1020 as a legacy gateway to a KX-NS1000, refer to your
KX-NS1020 Installation Manual.
42 Installation Manual
2.1.1 System Configurations
To Next Page
Loading...
