5.5 Programming a One-look Network
The
Add Site Wizard, which is run from the Home Screen of the Master unit, will add other KX-NS series PBXs
connected to the private IP network to your One-look network as Slave units.
Notice
When using a One-look network, do not disable the PBX
’s FTP server settings. For details, refer to
"28.2.2 Network Service—[2-2] Server Feature—FTP" in the PC Programming Manual.
Note
The PBX to be added must have been configured as a Slave unit using the Easy Setup Wizard.
For details about Easy Setup Wizard, see "5.4.1 Easy Setup Wizard".
1. To start the Add Site Wizard, click the Add Slave button
( ) on the Home screen.
2. Follow the prompts of the Add Site Wizard to complete
following settings:
• PBX Setting
• WAN Setting
• Registration Setting
• SNTP / Daylight Saving
• Maintenance Setting
Note
• The parameters which appear in the settings
above are described in
"5.4.1 Easy Setup
Wizard".
• If 2 or more sites will be added to the One-look
network, repeat steps 1 to 2 for each site.
3.
After the Add Site Wizard is completed, click on the
Home screen, and then click Registration on the List
View.
4. A list of KX-NS
series PBXs set up as Slave units will be
displayed under Available Site.
Select PBXs by their assigned site names and click the
right arrow to move them to Selected Site for
Registration.
Click Next to start the registration process.
5. On the Registration screen, the status of PBXs being
registered is displayed.
6. On the Registration
screen, the result of the registration
process is shown. Click Close to continue.
Registered Slave PBXs can now be viewed and selected on the Home Screen for programming.
MASTER LED Transition
When
adding Slave units, the MASTER LED of each KX-NS1000 PBX changes as shown in the following table:
Installation Manual 229
5.5 Programming a One-look Network
To Next Page
Loading...
