5.9.2 De-registering IP Telephones
Note
For details about de-registering IP
-CSs, refer to the documentation for the IP-CS.
De-registration of IP-PTs or KX-UT Series SIP Phones
1. Make sure the IP
Terminal Registration Mode is set to
Manual.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot ® Site Property ® Main.
b. In the Main tab, select Manual for IP Terminal
Registration Mode.
c. Click OK.
2.
a. Click Setup ® PBX Configuration ®
Configuration ® Slot.
b. For IP-PTs:
Click Virtual ® V-IPEXT32.
For KX-UT series SIP phones:
Click Virtual ® V-UTEXT32.
c. For IP-PTs:
Move the mouse pointer over the V-IPEXT32 card
(Virtual 32-Channel VoIP Extension Card
).
For KX-UT series SIP phones:
Move the mouse pointer over the V-UTEXT32 card
(Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
d. Click Port Property.
3. Click De-registration.
A dialogue box will appear. Registered extension
numbers and names are displayed on the left.
4.
a. Highlight numbers and names and click the right
arrow to select them for de-registration.
b. Click Next.
A dialogue box will appear.
c. Click Confirm.
• If the de-registration is successful, the dialogue
box will show "De
-registration succeed!".
d. Click Close.
Once the IP-PT
or SIP phone is successfully de-registered, the status of the IP telephone will update to show
"None".
Installation Manual 285
5.9.2 De-registering IP Telephones
To Next Page
Loading...
